Olympus PT-019 Bedienungsanleitung PDF herunterladen (Seite 31)

E-30

(3) In case of the following handling with a camera loaded into the Case,

trouble or breakage may be caused for the Case and/or the loaded

camera. Always avoid such handling.

(a) Hitting other objects

(b) Dropping

(4) When the Case is not used for a long time, trouble from formation of

mold etc. may be caused. Before use, confirm the operation of all

operation parts and perform the advance test and the final test.

Q4 : What cautions must be observed when opening and closing the Case?

A4 : Pay special attention to the following items.

(1) Do not open and close the Case at locations with water spray or sand

spray.

(2) Wipe off all waterdrops from the gap between the front lid and the rear lid

and around projections and recesses such as the buckles. When this is

not done, entry of waterdrops into the Case is to be feared at the time of

opening and closing.

(3) When opening the Case, take care that no water will drip from your hair

or body into the Case or onto the camera.

(4) When the Case is open, check that there is no attachment of sand, fibers

or other foreign matter to the O-ring and the O-ring contact surface on

the front lid.

(5) Do not touch the camera or the image storage with your hands to which

sea water is sticking.

(6) If you should detect waterdrops or other signs of water leakage while

shooting, immediately end the dive, perform the water leakage test

again, and confirm that there is no leakage. If the camera is wet, wipe off

any moisture and check the operation.

Q5 : How should the Case be handled after use?

A5 : After use, take out the camera as soon as possible and wash the Case

with pure water. In case of use in the ocean, it is effective to immerse the

Case for a certain time in pure water to remove any salt. Operate the

buttons and levers under water to turn the shafts and wash off any salt.

After washing, use a dry cloth without any salt on it to wipe off any

moisture and dry the Case in the shade. Do not use hot air from a hair

drier or the like and do not dry the Case under direct sunlight. Exposure

to high temperatures or direct sunlight may cause deformation,

discoloration or breakage of the Case and deterioration of the O-ring.

Wipe the inside of the Case with a soft cloth not causing any fibers.

Remove the O-ring, wipe off any salt, sand, dust, etc., and also clean the

O-ring groove and the O-ring contact surface in the same way and then

PT_019_en.qxd 2003.9.19 2:13 PM ページ E-30 (1,1)

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 37 38

Keine Kommentare

Olympus PT-019 Bedienungsanleitung Seite 31