PT-037 Instruction Manual©2007 Printed in Chinahttp://www.olympus.com/ VS018603PT-037SP-550UZ/SP-560UZPT-037_1-4.fm 1 ページ 2007年8月6日 月曜日 午前10時40
EN 10En1. PreparationsCheck the contents of the package.Check that all accessories are in the box.Contact your dealer if accessories are missing or da
EN 11EnNames of the partsPT037_EN.book Page 11 Monday, August 6, 2007 10:48 AM
EN 12En***1 Palm grip2 Diffuser mount3 Shutter lever4 Zoom lever5 Accessory mount6 Front lid7 Buckle hook8 Buckle lock/unlock levers9 # button (Flash
EN 13EnAttach the diffuser.Attach the diffuser on the Case.CAUTION:• Attach the diffuser correctly as shown in the future. If the camera or diffuser d
EN 14EnInstall the strap.Install the strap on the Case body.Master the basic operation.Please master the basic operation of the Case before taking pic
EN 15EnHow to Press the Shutter LeverWhen pressing the shutter lever, press it gently to prevent camera shake.Note:For details on operation of the shu
EN 16EnSetting the Zoom LeverWhen loading the digital camera in the Case, fit the projecting part of the zoom lever of the digital camera into the rec
EN 17EnHow to Use the h ButtonPress the h button to switch the camera shake correction function ON or OFF.CAUTION:• The camera shake correction functi
EN 18En2. Advance Check of the CaseAdvance test before useThis Case has been the subject of thorough quality control for the parts during the manufact
EN 19En3. Install the digital camera.Check the digital camera.Check the digital camera before loading it in the Case.Battery ConfirmationThe flash is
EN 2EnIntroductionzUnauthorized copying of this manual in part or in full, except for private use, is prohibited. Unauthorized reproduction is strictl
EN 20EnCheck the camera’s operation.Check if the camera functions normally as described in its instruction manual. After checking, press the camera’s
EN 21EnLoad the digital camera.1 Confirm that the digital camera is OFF.2 Pull up the mode dial knob on the rear-lid of the Case.3 Insert the digital
EN 22EnSet the mode dial knob.Make sure the camera is loaded properly.Check the following points before sealing the Case.• Is the digital camera loade
EN 23EnSeal the Case.Attach the special balance weight (optionally available).Lock the two buckles in the following order as shown in the figure.1 Fir
EN 24EnCheck the operation of the loaded camera.After sealing the Case, check that the camera functions normally.1 Push the POWER button on the Case a
EN 25EnMount/remove the LCD hoodMounting: Fit the projected sections of the LCD hood into the guides above and below the LCD monitor window.Removing:
EN 26EnFinal Test (Water Leakage Test)The final test after loading the camera is explained below. This is the only way to eliminate worry about possib
EN 27En4. Taking Pictures Under WaterHow to use the hand strapUsing the flashTaking pictures.Confirm the picture on the LCD monitor.This Case uses the
EN 28En5. Underwater Shooting According to the Scene TypeThe camera incorporates the following shooting scene modes. Select the one best suited to the
EN 29EnHow to select the shooting sceneSet the mode dial (1) on the Case to “SCN”, and press the up/down arrow pad (2) to select Underwater Wide-Angle
EN 3EnFor safe useThis instruction manual uses various pictographs for correct use of the product and to prevent danger to the user and other persons
EN 30En6. Handling After ShootingWipe off any waterdrop.After completing the shooting and returning to land, wipe off any water drop sticking to the C
EN 31EnTake out the digital camera.Open the Case carefully and take the digital camera out.CAUTION:• Always place the opened Case with the O-ring side
EN 32EnWash the Case with pure water.After use, seal the Case again after taking out the camera and wash it sufficiently in pure water as soon as poss
EN 33En7. Maintaining the Waterproof FunctionWhenever you open the rear lid of the Case, always be sure to perform the O-ring maintenance operation as
EN 34EnRemove any sand, dirt, etc.After visually checking that dirt has been removed from the O-ring, checks for sand and other foreign matter adhered
EN 35EnInstall the O-ring.Confirm that no foreign matter is adhered, apply a thin coat of the grease provided to the O-ring, and fit the O-ring into t
EN 36EnReplace consumable parts.• The O-ring is a consumable part. Regardless of the number of times the Case is used, it is recommended that the O-ri
EN 37En8. AppendixQ & A on the use of the PT-037Q1: What digital camera models can be used with this product?A1: This product (PT-037) is designed
EN 38En2 When the Case is used, left or stored at the following locations,defective operation or trouble may occur. This should beavoided.• Places whe
EN 39EnQ5: How should the Case be handled after use?A5: After use, take out the camera as soon as possible and wash the Case with pure water. In case
EN 4EnCAUTION1 Do not disassemble or modify this product. This may cause water leakage or trouble. In case of disassembly or modification by persons o
EN 40EnQ8: What are the causes for entry of water?A8: The main causes for the entry of water are shown below. Please check with special care.1 The O-r
EN 41En5 Deterioration of the O-ring is accelerated by the use conditionsand the storage conditions. Replace the O-ring immediately witha new one if i
EN 42EnSpecifications* We reserve the right to change the external appearance and the specifications without notice.3 Silica gel (SILCA-5S): This is a
PT037_EN.book Page 43 Monday, August 6, 2007 10:48 AM
EN 5EnSetting the underwater shooting scene modezThe SP-550UZ/SP-560UZ camera incorporate several shooting scene modes for underwater shooting, includ
EN 6En5 Apply the specified silicone O-ring grease to the O-ring.6The waterproof function is not effective when the O-ring is not installed correctly.
EN 7Enimpacts or heavy objects are placed onto it, the digital camera may become damaged. Please handle it with sufficient care.zWhen the product is n
EN 8EnContentsIntroduction ...... 2Please read the following items before use ...
EN 9EnSet the mode dial knob. ..............22Make sure the camera is loaded properly.......
Kommentare zu diesen Handbüchern